[BD2400F]
BugDorm-2400F Insect Rearing Tent (fine mesh, 75x75x115 cm, pack of one)

US$106.00

click to enlarge

Of the same dimensions as the BugDorm-2400 insect tent, instead of using 96 x 26 mesh Polyester, this BugDorm-2400F is sewn using fine 150 x 150 mesh Nylon to effectively keep aphids, thrips, and parasitic wasps from escaping or entering the tent.

Fabric Comparisons: per Square Inch / per Square Centimeter / Microscopic

BugDorm-2400F insect tent is constructed so that support poles are outside the enclosure. There are no places for insects to hide inside BugDorm-2400.

Similar Products: BugDorm-2 Series Insect Rearing Tents
Similar Products: Emergence Traps

Contents per Tent
1 BugDorm
12 Splints (2-way)
4 Splints (3-way)
8 Short Poles (37 cm)
10 Long Poles (55 cm)

Specifications

Assembly

Connect two short poles with one 2-way splint to form each side of base.
Thread one assembled pole from Step 1 into each of four sleeves on base of BugDorm.
Use 3-way splints to complete base frame.
Thread one long pole through each of BugDorm's four lower sleeves and into top of each 3-way splint used in Step 3.
Push a 2-way splint into top of each pole used in Step 4.
Thread one long pole through each of BugDorm's four upper sleeves and into top half of each 2-way splint used in Step 5.
Push a 2-way splint into top of each pole used in Step 6.
Thread remaining two poles through tabs on top of BugDorm to form an X and into top half of each 2-way splint used in Step 7.
Tie ribbons around crossed poles of Step 8.

Caution

Operating Temperature: -10 to 60°C
Nylon fabric degrades easily in UV ray. Please avoid long-term exposure to direct sunlight.
When trying to take assembled tent apart, you may find a few poles locked in the splints. Do not force them apart, or you may rip the seam. Try to find a looser connection elsewhere.

Qty:

Customers who bought this product also purchased

[BD2400F]BugDorm-2400F Insect Rearing Tent (fine mesh, 75x75x115 cm, pack of one)